Homemade Wallmount Mask Stands ?

[robocop ●]

Hi, So what do you guys use to hang your masks on the wall. I have seen stand you can buy but i would rather make one. Thanks

[Homicidal#9 ●]

here is what i have used for wall mount stands. I go and buy several of the wood plaques from michael's or another craft store. I then buy some pvc tubing, some 45 degree angle joints and some pvc toppers. I use a drill to cut out the necessary hole in the plaque to fit a piece of around 4-6 inch pvc. I then add the 45 degree joint and add another piece of 12 in to 16 inch pvc. Finally i had the topper. I have used 90 degree angle joints in the past, but i always ended up having to make the initial pvc from the wallmount much longer if i did.take care,Tommy

[Cory ●]

That's actually brilliant...and simple...and wtf didn't I think of that?!?!?!

[gummi ●]

This may sound a little strange, but one of the mods over at MM.net posted about using plastic spatulas. Just screw the flat part of the spatula to the wall with the handle angeled outward, stuff the mask, and shove it down onto the spatula. I've never used this method personally, but I've seen pictures that he posted, and it works out great. May be something to consider if your looking for a cheap alternative. Also, check out this link: <a href=\"http://cgi.ebay.com/Wall-Bracket-Helmet-Mask-Stand-Flat-Black-Fin-14-Tall_W0QQitemZ350097093099QQihZ022QQcategoryZ36076QQcmdZViewItemQQ_trksidZp1742.153.l1262\" target=\"_blank\">John's Hat and Helmet Stands</a>. This guy offers terrific stands at the most reasonable price I've seen anywhere. I use his stands for all of my masks. At $12.95 a piece you just can't beat them. He makes a lot of different varieties also.